Analyzing the Operating Common Sense of Micro Tillers

1. Operators of micro tillage machines must undergo professional training or thoroughly read the machine manual before operating. Personnel who are not familiar with the operation methods of the machine are strictly prohibited from operating.
2. Micro tiller operators should pay special attention to the safety warning signs on the machine, carefully read the content of the signs, and indicate to other operators.
3. Operators of micro tillers should pay attention to preventing injuries caused by entanglement of moving parts. Check if all exposed rotating parts are well protected.
4. Microtiller operators are strictly prohibited from working under fatigue to avoid accidents.
5. Before each operation, it is necessary to check whether the engine and transmission box have sufficient lubricating oil.
6. Before use, it is necessary to check all components, transmission boxes, and engine bolts for looseness or detachment.
7. Check whether each operating component (position) is flexible and effective.
8. When installing the plow blade, it is necessary to ensure that it is symmetrical on both sides and that the working edge faces forward, otherwise it cannot be used normally.
9. Before starting the engine, it is necessary to check whether the clutch is in the disengaged position and whether the gear lever is in the neutral position.
10. To ensure the normal operation of the engine and extend its service life, the engine must be running at no load after starting. It can only be started after 5 to 10 minutes of hot driving, and it is best not to work at high speeds or heavy loads for 1 to 2 hours before starting work. If there is a phenomenon of speeding when the engine starts, the fuel supply should be quickly cut off or the intake duct should be blocked to immediately shut down the engine.
11. The height of the resistance rod should be adjusted at any time according to the working situation, and the body should be kept in a horizontal position to prevent damage to the engine due to poor lubrication caused by excessive engine tilting.
12. During the operation process, it is prohibited to touch various rotating tools to avoid stabbing, and to stay away from the high-temperature area of the exhaust pipe to be careful of burns.
13. When replacing tools, removing weeds, and conducting inspections and repairs, the engine must be stopped before proceeding.
14. It is strictly prohibited to increase the operating speed of this machine in any way.
15. The engine speed, power, and other components have been adjusted normally on the experimental bench, and arbitrary adjustments are strictly prohibited.
16. The machine has no lighting device and it is strictly prohibited to work at night.
17. Micro tillers should operate at low speeds near fields such as corners, ditches, caves, and channels.
18. Stop the machine and avoid ignition when adding oil.
19. When working in a sloping area, attention should be paid to machine balance, and operations can be carried out along the slope direction, with a slope of less than 25 degrees.
20. When the machine is running, it is strictly prohibited to approach or touch rotating parts to avoid accidents.
21. It is strictly prohibited to hang the micro tiller bucket.